I have a 411 PCM and I used PCM Hammer to update it to the 2156 OS. I am swapping a Gen 3 5.3 V8 with 4L80 into a Dodge. I would like to segment swap the 4L80 portion since that combo was never sold by GM. I see the only 2156 file with a 4L80 here is for a pre-LS (L31) Express van. Can I use that file for the segment swap?
Thanks.
UPDATE
I used LS Droid to segment swap the Van 4L80 file (see below), and PCM Hammer to write it to my 411 PCM- no errors. I did the transmission and transmission diagnostics. The base file was the 2002 Silverado 5.3 DBC no EGR from post #8, I modified it by changing the tach output from 6/6 to 3/3 and disabled some MIL codes for the rear O2 sensors. I'll update here if it works, I'm still a ways from starting my swapped engine. I'm attaching the new bin file.
UPDATE #2
When I checked the segment swapped file with HP Tuners, it showed as backwards- the engine was a 5.7 not 5.3, and the trans was a 4L60, not 4L80. As such, I don't think this file is usable as-is.
UPDATE #3
I found my error was in LS Droid. I presumed the green button meant you were swapping that function, and the red one meant you were not. That's backwards. I deleted the file until I can fix it.
UPDATE #4 11/7/20
Updated file attached. My truck developed a mechanical problem (oil leak), but the tune allowed it to run OK. As I recall, it has a number of MIL codes disabled such as EGR and secondary O2 sensors, AC and VATS are disabled, and the tach hi/low resolutions were modified. I was not able to drive the truck to verify the trans shifted properly, so use at your own risk. It did show up as a 5.3/4L80 in HP Tuners though.
Last edited by 95_C4; 11-08-2020 at 01:41 AM. Reason: Attached corrected file
Any luck on swapping the 5.3/4l80 combo yet? I could use it if it's done
Just updated the prior post with the revised file. Give it a try and let me know how it goes, I'm down for at least a couple of weeks.
Possibly someone will share a stock 2002 Camaro LS1 with Manual .bin
Thanks in advance,
dave w
A little off reach of the thread but hth's
-Carl
I’m looking for 5.3, 2wd, 4L60E, truck MAF and stock LS1 intake calibration/bin.
I am needing a 2002 LS1 w/Auto trans bin. If anybody can help me out with this I will be forever in your debt!
Last edited by Eddieg9600; 08-21-2021 at 01:22 AM.
Whatever happened with the segment swapped 5.3 4L80e? Regardless, I just recently grabbed a PCM from a 2002 YukonXL with an LQ4 (verified pistons) with an AWD 4l60e/65e not sure which. It is also DBW. This is the stock tune pulled with PCM Hammer.
Last edited by MrHappy013; 06-16-2021 at 06:49 AM.
is this still available? for some reason it won't download for me
2002 Chevrolet YukonXL LQ4 DBW 4L60e AWD (12212156).bin (512.0 KB, 45 views)
Bookmarks