Quote Originally Posted by doc_rock View Post
just stepped through everything, and I think I have it right.
The only confusion I have is a couple places where referencing all these files for copy/paste/etc gets confusing.
I'm assuming that I save a new S_AUJP file, and after that point in step 1.4 of the MUSTREADME doc, you would then call the S_AUJP you've saved out to, not the original.

or am I screwing up saving it off as a different name?
Looking at the 2 bins in your zip in Post #11, I have no idea what's been done.
JMD012-355-tpi-7730-6_08_06_JMH.bin: This BIN is total garbage ans is not $8d. Have no idea what it is.
S_AUJP v6-28jmh682020.BIN: This is essentially the released BIN without change.
So not surprised it won't run.

Let's go back to ground zero.

1.
Please post up the bin file you extracted from the "custom chip"

2.
Once that's available, I'll copy that calibration to S_AUJP and post it so you'll have a "starting point" bin.

But when you post your bin file, you also need to describe how you will burn that bin to a chip so it can be used, or what intermediary device you will be using in place of a burned chip.