I am wondering if maybe modifying the factory setting by +/- 3% ~ 7%. If for example the table I posted, was multiplied by 1.03 (to increase 3%) or multiplied by .93 (to decrease 7%) it might be close enough to work? In my thinking, the injector is an inductor, so without going into electronics detail, I'm thinking the inductance is not going to vary that much between injectors. The injectors are designed around a nominal 14 volts. Not to confuse anyone, but 4 injectors are in parallel so figuring the inductance of the 4 injectors in parallel circuit would be a good idea. I'm thinking the impedance of one TBI injector is very close to the impedance of 4 port fuel injectors in parallel.

I really don't know, in a data log, if the changes in a voltage offset helps or not?

dave w