I'm looking for a 4l60e stand alone transmission controller. This will be for a 1975 C10 with a 350 SBC. I'm located in NC.
I'm looking for a 4l60e stand alone transmission controller. This will be for a 1975 C10 with a 350 SBC. I'm located in NC.
Last edited by custodian; 04-16-2021 at 02:28 PM.
I am currently controlling a 4L85E with a 0411 running a carb. Just needs RPM input to the crank sensor, vehicle speed, coolant temp, MAP and TPS signals to properly shift. The 0411 is also controlling my vortec distributor, cooling fans and a/c compresssor as well as outputing a signal for the speedo and abs. Ran my 97 Express van for over a year with a carb on it.
Maybe a standalone 16197427 94-95 TBI computer would be an option? The link below has information for the 4L80E, the 4L60E would be similar:
https://sites.google.com/site/astros...h-16197427-ecm
Maybe the 1975 C10 has a HEI distributor that can trigger the 16197427 computer.
Maybe there is a way to fabricate a Throttle Position sensor to the 1975 C10.
dave w
Is this a DIY project that you are sourcing parts and / or technical drawings for?
Are you looking for a Plug-n-Play "junk yard fabricated" 4L60E controller?
dave w
Cool, OBD2 trans controller . Gearhead-efi link for OBD2 Tuning: http://www.gearhead-efi.com/Fuel-Inj...2-OBDII-Tuning
dave w
He's using the bin and xdf files from an 02 Chevrolet Express Van with a 5.7/4l60e and deleting what is not necessary for the trans operation. I'm still learning on this stuff. There's a lot of great info on this site compared to a couple of other tuning sites I joined and have since left.
This is what I've found so far and I'll post it for everyone to see. I think I have the correct info for the inputs for the 00-02 4l60e.
The diagrams are for the transmission plug to the computer. If anyone wants to chime in, feel FREE to do so. I'll post the 03-07 transmission diagram later and the 4l80e is similar to the 00-02 diagram. I'm sure I found the inputs for the "CARBED" vehicles with an after market TPS, which I'll post later.
After all this is figured out, the computer will have to be setup to just run the trans. ALL the engine DTC's will have to be turned OFF with the exception of PO121, 122, 123, PO335, 336. You'll leave all the DTC's for the trans turned on. REMOVE all TORQUE MANAGEMENT and disable the ABUSE MODES in both engine and trans section.
If anyone sees that I'm missing something, please post it up.
20210504_090228[1].jpg
20210504_090241[1].jpg
The picture below might be helpful. Sometimes different year / make / model will have different wire colors than the picture below. Circuit function and circuit number supersede wire colors. What the heck, it's all copper on the inside of the insulation (the important stuff).
dave w
4L60E Pinout.jpg
Bookmarks