hi so ive got the pcm#16188051 but were would the bin# be ..94 roadmaster also on the pcm there was blpp also *86BLPPK1408766AG* and 16207211 thanks also how do I know wich $ee or $eeb to use
hi so ive got the pcm#16188051 but were would the bin# be ..94 roadmaster also on the pcm there was blpp also *86BLPPK1408766AG* and 16207211 thanks also how do I know wich $ee or $eeb to use
Last edited by swat455; 04-21-2012 at 12:28 AM.
look here for some good info. http://www.gearhead-efi.com/Fuel-Inj...rmation-EE-EEB
you should have a 4 digit BCC code not a bin number per se. when you find it you can look it up on the site below
http://www.gearhead-efi.com/BCCFind/
/BLPP/ ***Unable to locate bcc***
Last edited by PJG1173; 04-21-2012 at 12:41 AM.
87 4Runner, 15" spring lift, 3" body, chevy vortec 355, 5.29 gears, 38.5x15.5x15" Boggers, 280hr, 16168625 running $0D
93 S10, 36x12.5x15 TSL's, custom turbo headers, 266HR cam, p&p vortec heads, $0D Marine MPFI with 8psi boost.
05 Silverado, 2' lift, 4" exhaust, Bully Dog programmer,
BLPP sounds like the BCC from your information. We don't seem to have a copy of that bin for me to check for you...
The LT1 PCM does not have a removable chip like other ECM/PCM. It is a flash prom through ALDL port. You will need a cable to connect to car and laptop and software program called WinFlash from TunerCat. Once you get the bin downloaded with Winflash you can look at injector flow or cylinder volume in TunerPro with $EE and if numbers are strange it is an early model $EEB.
Then you can use TunerPro to adjust the bin and record data.
As a side note if it is an early $EEB you can use an $EE bin file to reflash your PCM.
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
but how do i find it ???i see the pcm# on this site but what about the bcc#
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
thanks I put that reply on before you put yours on so thats what ill do thank you
so i got the 30 day trial cats winflash read my pcm.. but i cant get it to transfer over to tunerpro to run it what am i doing wrong and also to put it on here
Well if you used Winflash to read the PCM and saved the file, then you need the $EE XDF in TunerPro to read the file. Read the tutorial for TunerPro, first thread here:
http://www.gearhead-efi.com/Fuel-Inj...ro-Tuning-Talk
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
Bookmarks