I've been reading. Not looking for a hand out. Was looking for correct XDF as that's what I read I needed. I know how to do most of the other stuff once I'm in. Assumed that's all I needed. From what I've gathered this far. Also was looking to see if there was an xdf that was close, I've seen others suggest other SNs that would work.
Last edited by KevinReed1987; 10-31-2021 at 03:58 PM.
I'm not aware that an XDF has ever been created for that particular OS - XDF files are very hard to create. Your later 2006 OS, engine and transmission combination will require a 1 megabyte PCM OS and there is only one good, richly featured XDF for that OS - last four digits of the OS = 7603. You will be overwriting your 12613248 OS with xxxx7603 after editing 7603 with its mated and married 7603 XDF using the Tuner Pro RT editing app.
Do you have a bench harness with at least two amps of 13.8 VDC support?
What tool will you be using to perform the writing to the PCM? I like LS Droid and PCM Hammer but have dabbled with Universal Patcher to fix self inflicted checksum errors - not to write the file to the PCM.
Rick
Last edited by B52Bombardier1; 10-31-2021 at 05:09 PM.
1970 Chevy El Camino, LM7 Engine, 4L60E - Two 896 and two 0411 PCM's
I didn't think I needed a bench tester I had contemplated doing it, but I'm just using it in vehicle with PCM Hammer, I unplugged most of my other module relays. I read a few guys doing it in vehicle, now correct me if I'm wrong is that not a positive way to do it? I watched a few vids "FixedUntilBroken" on YouTube, he said you can do it in vehicle unless doing multiple is why most people use bench, and I had it hooked to a battery charger while loading it, and I keep it on 14v, and I believe lowest setting was 4amps.
yes it was for no vats for engine swap into a vehicle that didnt have a ls. if switching to a 7603 os (operating system) you will need a new eletric foot pedal and module. 2006 is different for the os you have. truck will not responde well. may need to swap something with throttle body or injectors to match the 7603 os. 7603 is the only xdf i know of for the p59 pcm 1mb memory.
No... Do I need one? I've been reading/writing without benchtop harness since 1995.Do you have a bench harness with at least two amps of 13.8 VDC support?
It may be important to confirm the charger output is steady with no A/C component. If you have a spare battery or a jump pack that might be better.I had it hooked to a battery charger while loading it,
My charger can pulse or do consistent charging, I can put it on timer and change voltages to 6/12/24 low medium high. Im sure it's there's no issues there. But sounds like I'll have to change a few things before I can. Also this is a 2007 Silverado classic, if that confused you, I said 2006 cause alot of people assume 2007 is NBS.
Is that what I'm going to have to do to succeed in this is change pedal and TB ?
Not a bit. My shop truck is a 2007 Silverado NBS. I usually say it's an '08 to make it easier.Also this is a 2007 Silverado classic, if that confused you, I said 2006 cause alot of people assume 2007 is NBS.
Posting Permissions
Reply With Quote
Bookmarks