Does anyone happed to have the dissasembly tool and a pair of calipers handy to measure the diameter of the hole in the end?
i'm going to turn one on my lathe and couldn't find the diameter of the hole anywhere on line.
Does anyone happed to have the dissasembly tool and a pair of calipers handy to measure the diameter of the hole in the end?
i'm going to turn one on my lathe and couldn't find the diameter of the hole anywhere on line.
I don’t own the tool but after one of my kids broke the antenna off one of his remote control car controller, one of the sections is a perfect fit. I’m out and about but could take some measurements off of that.
Edit: Mic'd it at .135" OD and for the inside, I was able to insert a 1/8" drill bit into it and that mic'd out to .122". I do have some disassembled weather pack connectors and mic'd the male connector loosely @ ~.120"
Last edited by stew86MCSS396; 10-24-2022 at 08:11 AM.
Bookmarks