OK, I've made some changes to the 95 G series.bin mostly just changed the cyl. volume and injector specs for the 305,ran the speed limit up to 255,raised the rev limit up tp 5000 rpm,gave it a little more timing and raised the TCC to 35mph. On the 7747 it was going into third gear at the same the TC was locking(30mph)which made a harsh third gear shift at light throttle. I burned the chip with no issues save one. The original .bin in the 7427 was loaded at the bottom of the chip(as viewed on the buffer)and when I burned the new chip it burned it into the top. In the help section of TP it states to load the chip from 000000>00FFFF and that's where it put it but that's at the top of the chip. Is this going to create a problem or can the PCM find it in that region?