What setting do you have for PRNDL ?
What setting do you have for PRNDL ?
No need to re-invent the wheel. But we can make it better
I beleive im at none atm, I can send you the whole bin if u wanna take a look real quick. im sure something must be going on in there, its definatly going into limp mode because every code triggersOriginally Posted by ralmo94
Have you verified fuses are good, and is the trans known good? Worked when pulled?
No need to re-invent the wheel. But we can make it better
yeah I checked fuse, and the ecu is scanning properly and monitoring rpom and tps like it should so Im assuming this is good.
Trans is unknown, but throwing out every single solenoid and tcc electrical code at once seems odd, and et kinda want to work like it should for a sec when I erase them. all the wiringharness is complete from a 2002 blazer. thats why ide rather make sure the programation is good or not before opening up the trans and all that.
https://sites.google.com/site/sloppy...ans-controller
this is what I followed, in my case, trans is already wired up to the ecu so I only spliced all the required 12v ground and sensor into the 0411 from the astro and seems to be working as it should. I could not follow the instruction on tuning since I only have tunerpro
Might not be a bad idea.
Last edited by ralmo94; 12-24-2023 at 02:35 AM.
No need to re-invent the wheel. But we can make it better
there it is
Posting Permissions
Reply With Quote
Bookmarks