Tried checking parameters on Trans tab, but did not see anything change. The engine was not running, ignition was on.
Tried checking parameters on Trans tab, but did not see anything change. The engine was not running, ignition was on.
Yes, I did. As soon as I click Stream, data starts populating. Maybe I did not look good enough. Or engine should be running... I will double check.
it was just a guess, i'm sure road test later will tell you whats up. if its still not working we might be able to figure out why and patch it for you.
Following along - planning on adding a performance mode switch to my 9C1, but haven't wired it up yet.
Did a quick look and didn't see the performance mode state in eehack or Tunerpro RT, but it looks like it's available in scan9495.
You might want to give that a try if you haven't already.
Hope this helps,
Jim
1995 Caprice 9C1 LT1 - 4.10s, Dynomax Catback, K&N Cold Air Kit, Other Little Stuff
1996 Caprice 9C1 LT1 - 3.73s, Stock
Performance Switch State is in EEHack, you just have to adjust the visibility slider on the right side in order to make it visible. ;)
1990 Corvette (Manual)
1994 Corvette (Automatic)
1995 Corvette (Manual)
everything in the factory datastream should be in eehack... if not please let me know and we can add it. there's so much stuff that I had to add that slider otherwise new tuners would be overwhelmed.
Bookmarks