VEFixer is about as easy to use as it gets. There are basically 5 steps to this:
1.) Log data and save BLM/INT tables out of WinALDL.
2.) Open BLM/INT tables with MS Excel. Make sure you get them in the right format.
3.) Copy and paste your choice of the various BLM/INT tables into the proper location in the spread sheet. Make sure you are consistent...like using Wide Avg BLM with Wide Avg INT and so forth. This is where you have to be a little intuitive. If your BLM or INT table has any zeroes in it, they will show up in the "Correction Factor" table as zeroes and they will screw up the calculations for the new VE table. Replace the zeroes in the BLM and INT tables with 1.00 and it will be much easier on you later.
4.) Copy and paste your current VE table into the cells that say "Old VE%1"
5.) Copy and paste your new VE table to the other worksheet by using "Copy" and "Paste Special" then select "Values"
Now that you have a copy of your new VE table in the spreadsheet, you are ready to put the changes into your BIN. I just make note of which cells changed in the VE table and manually type them into the BIN.