The file
The file
Perfect, if you could repost it I will give it a try hopefully tonight.
So I've tried swapping the manual and manual diag segments to the lq9 file, it was successful in the process but the result that it would not Rev past 1500 rpm with or without wheel speed. I have read about a simular experience on another post.
The next thing I tried was to swap the engine cal and engine diag segments to the manual bin. The result was a crank no start situation. The only change that was made aside from this was deleting the vats.
My question is can someone get me this file in .bin format 1GCEK14V14Z268035. It would be greatly appreciated as there seems to be a little more than just swapping the segments to get this combination to work. Thanks
Ah, got it, thanks
To Segment Swap with U/P
Utilities > Patcher
Original File - Select the one with the engine cal you want to use
Swap Segments
Select segment to swap [ trans cal ]
Extract from File [ file with segment you want to swap in ]
Apply
Extract from file [trans diag ]
Apply
OK
Save Bin { give it a new name as [ Seg Swaped LQ9 Manual ] or something }
No need to re-invent the wheel. But we can make it better
More Screen Shots
Side Note, Both Files Show stock Checksums in U/P
File with Manual Trans I used
1GCEC14X04Z123261_4_3_2WD_manual_(12587603)
From Same thread the Escalade bin is on
Last edited by ralmo94; 04-16-2022 at 07:51 PM.
No need to re-invent the wheel. But we can make it better
Bookmarks